how to remove old protective film from acrylic sheet
Moisten a soft cloth or sponge with acetone. Gently apply the acetone to the painted area, rubbing in a circular motion. Continue to wipe away the paint, periodically rinsing the cloth or sponge and reapplying acetone as needed. Once the paint is removed, rinse the plexiglass surface with water and dry it thoroughly.
Heat the car surface for two minutes. Use the plastic implement to push under the film and remove it. Use the 3M Adhesive Remover to get the rest of the film. Get rid of the remainder of the adhesive with a microfiber towel and 3M Adhesive Remover. When the adhesive is removed, get a different microfiber towel and rub the surface of the car.
3. Since it sounds like the film is disintegrating when you try to peel it: Tape the whole surface, peel the tape (and film) off. You'll need a tape with an adhesive that's more stubborn that the film-to-cabinet bond. I'd probably start with plain old packing tape - fairly strong, usually has good adhesive, inexpensive, can be had wide.Cleaning Plexiglass. To clean plexiglass, gently dust it off using a microfiber cloth. Then, mix mild soap with warm water, apply the solution with a soft cloth, and wipe dry. Avoid using cleaners containing ammonia or alcohol. How to clean Acrylic/Plexiglass is a question making many DIYers scratch their heads for the right reason.Repeat as necessary. If this leaves residue along the edge of the decal, clean that in a similar fashion, but being very meticulous not to allow anything to go off the edge. Move parallel to the edge, going just next to it. If any material, including softened residue, gets onto the seam of the decal, wipe it immediately. Use a plastic or metal razor blade or a hobby knife to lift the vinyl. Heat gun: Sometimes, you'll need to heat up a surface to remove vinyl decals. To heat up the surface, it's often best to use a heat gun or a hair dryer. Adhesive remover: After removing the adhesive, there will usually be some left behind. Regular cleaning solutions will not A short video showing you how to remove sticky back plastic when it;s been on the surface for some time! A hairdryer warms the vinyl and the adhesive making Bestine solvent dissolves the adhesive that holds the paper on without damaging the acrylic, and rinses off fairly easily afterwards. For extra ultra removal action, an ultrasonic cleaner (for jewelry, lab equipment, etc) can also be used to clean off acrylic dust from large-scale deep etching. HOW TO REMOVE PROTECTION FILM ON CAR Check Out Our Website: http://mechaniclifestyle.comHey guys, in this video we will show you how to get rid off and remov